14170 Factory Meyer 8'6" SV2 Trip Edge Weldment Kit 5/8"

Meyer 14170 – Trip Edge Weldment with 5/8" Holes

The Meyer 14170 is a heavy-duty trip edge weldment designed for use with Meyer Super-V and Super-V2 snow plows 8.5' only. This component is crucial to the plow’s ability to absorb impacts and reduce potential damage by allowing the edge to pivot when hitting obstacles. These often need replaced if you have run the cutting edge down to far.

This specific trip edge features 5/8" bolt holes and is used on the Meyer Factory 8'6" SV2 Trip Edge setup, where both the driver and passenger sides utilize part number 14170.

• Held in place with 1" pins (part #22438)

• Make sure to verify that this is the correct trip edge for your specific plow configuration

Note: Other Meyer models may use different trip edge weldments, and soem have 1/2" bolt holes.