Set Genuine Diamond 1.5x10 Power Angling Cylinder 817000 020 with Hose and Coupler

A New set  1.5x10" Genuine Diamond Power Angling Cylinders (part #817000 020). These were pulled out of new pump kits that we took apart (you get just what you see). They have hoses, couplers, and oil in them already. This was used on all the Diamond blades with 1" pin holes. Cylinder assembly #80061 and #80062. The hose is part #816000095034 and the elbow is part #8752202004004. The couplers on the hoses are part #22291 and #22292.

These are often all pitted and at that point should be replaced since those pits take in water and will cause freeze up in the pump. Get a new set on and flush all the fluid out. We have the hoses listed here for the swap.

Here are some measurements to be certain that this is what you need: the pin holes are 1", the port is 1/4" pipe thread and comes out the side of the cylinder, in the closed position the center of hole to center of hole is 17-1/4" and the closed end to end measures 18-3/4".

This is an OEM cylinder, but the aftermarket cylinders are part #1304100.