29675-1 V Plow Steel Center Cutting Edge Kit Western, Fisher, SnowEx

Steel Center Cutting Edge Kit # 29675-1. 

In this kit you get Driver Side 44891-1 and Passenger Side 44890-1.

In this kit you get two of the steel edges and the bolts and nuts needed for installation. This can be used with Western MVP plus, Western MVP3, SnowEx HDV or Fisher Xtreme V-plows and XV2. For the Installation Instructions, check this document.

The older NON-1 version (29675, 44891, 44890) had 2 square holes and this newer version has a slotted hole as shown.

Also replaces other versions 29675 and 44894, 44894-1.

Also available is 5/8" Thick Kit # 85357 - DS 85351 and PS 85352.

These come with cutting edge kits 44561-2, 44564-2, 44284-2, 44285-2, 44740-1, 44741-1, 44742-1, 44743-1, 44744-1, and 44567-2.

*Note: These can not be installed with a worn main cutting edge. If your edge has a lot of wear, these will sit below that edge. Make sure your cutting edge measures close to 6" - if not, that will need to be replaced as well. The part #s for the complete kits are listed above.