93275 Spreader Pre-wet 100-Gallon Expansion Tank Kit Western / Fisher / SnowEx

Pre-Wet Tank Kit # 93275.

This is for the Newer Spreaders Western Marauder, Fisher Tempest, and Snowex Renegade. These Stainless steel spreaders in 3, 4, and 5 yard will require the 200 Gallon kit with pump 93270 and this expansion kit will make it 300 Gallon. S300, S400, S500

This kit gives you the 2 50 gallon tanks 31991 ( 76430 cap, 76296 tank, 76447 fitting ) , and needed mounting brackets 79991, 76421, 79951, and plumbing 79349, D6963, 76299, 76359.  This will take it from 4 tanks to 6 tanks on the spreader.

The link for   Instructions  

INSTALLING AND PLUMBING THE 100 GALLON EXPANSION KIT
INSTALLING THE TANKS AND TRAYS
1. Unbolt the four 3/8" locknuts on the lower legs of 
the front side of the hopper, then refasten with the 
expansion tank trays in place.
2. Connect the two trays with the tank cross member 
variation required for hopper type. Using the 3/8" 
carriage bolts, washers, and locknuts to fasten.
3. Place the tank on the tray. Verify that the recess in 
the bottom of the tank is seated into the tray.
4. Use the 3/8" x 1" carriage bolt and 3/8" locknut to 
install the tank support strap with the button head 
facing the tank.
5. For eight foot 3-yard hoppers, replace the six 3/8" 
carriage bolts in the tiedown brackets with the 
supplied 3/8" 1-1/2" long carriage bolts fastening 
the J-bolt adapter plates to the outside.
For other hoppers, remove the necessary 
knockout for the J-bolt to go through the hopper 
wall.
6. Loop the 3/8" x 8" J-bolt through the tank support 
strap and insert it through the attachment hole. 
Loop the J-bolt so that the hook is facing upward.
7. For the J-bolt, place one 2" fender washer and 
locknut on the inside of the hopper with the 
locknut facing toward the chain. Tighten the nut 
toward the hopper body. 
NOTE: Do not use power tools to tighten the 
J-bolts; use hand tools only. Overtightening can 
cause galling of the stainless steel threads.
8. Cut the excess bolt length from the J-bolt if 
desired.