Genuine Meyer Diamond 1.5x8 Lift Cylinder 817000116 8" Stroke

Here is a new 1.5x8" Stroke Genuine Meyer / Diamond Power Lift Cylinder (part # 817000116.) This was used on several Meyer and Diamond plows.

These are often all pitted and at that point they should be replaced as those pits take in water and will cause freeze-up in the pump. So get a new one on there and flush all the fluid out. We have the hoses listed here for the swap. This can also be used on a Meyer plow with the H pump such as MDII or Plus plows.

Below are some measurements to make sure this is what you need:

The bolt holes are 5/8".

The port is 1/4 pipe thread and comes out the side of the cylinder.

In the closed position, the center of hole to center of hole is 14-3/4".

Closed end to end measures 16".

The top section steps down 1-1/8 to fit in place of a Meyer lift cylinder.