38800 New Brighter SnowEx & Blizzard Storm Seeker 11 Pin Plug Plow Light Kit

*Also check out the new Storm Seeker L.E.D. lights Snowex now offers, which is listed in related products (Part #72560). 
Here is a link to the parts breakdown for these lights.

SnowEx has a new updated version of the Halogen Storm Seeker lights (Part #38800). They are now dual bulb with H9 & H11 bulbs. These are a direct replacement to the Blizzard and SnowEx #28800 lights.

With this kit you get: Left Side Light #38801, Right Side Light #38802, Harness #38807 and Mounting Hardware.

The New Storm Seeker halogen headlamps from SnowEx offer significant durability and illumination improvements for users of SnowEx truck plows.

The Storm Seeker headlamps are uniquely designed to reliably deter water ingression. The reflector-to-housing seal features a built-in vent that allows moisture to exist, but not enter. In addition to fighting water ingression an improved lens seal uses dual adhesive bead channels to ensure secure attachment of the lens. The lamps have passed an IPX9K pressure washing protection test. They have also passed a humidity test thanks in part to improved venting through the use of Gore-Tex patches.

An enhanced mounting bracket design provides vibration dampening along with better structural balance and flexibility to withstand jarring shocks and vibrations from plow tripping events and general use.

To avoid interference with the hood the headlamp casing is 3 to 3.5 inches less deep than the previous lamp design, which allows the shallow casing to eliminate the need for additional brackets.

Replacing SnowEx’s previous single cavity headlamp, the Storm Seeker’s dual-cavity lamp allows individual cavities to be optimized for low and high beam functions. Using H9/H11 bulbs. The low beams are 17-percent brighter and 6-percent wider to put down more light in front of the plow and to the sides for safer plowing. High beams are 36-percent brighter and illuminate 35-percent farther allowing plow operators to see more of the road ahead.

If you are installing this kit on an old Blizzard PH1 you will also need bracket kit #98330.