15206 Aftermarket Meyer H Model Lift Ram Chrome Rod 8" E47H E60H E57H MDII Plus Diamond Plow Snow Plow

The Meyer part # is 15206. It is a 8" x 1-1/8" rod. If you have a non H model pump, that is a 6" stroke and you would need part # 15208.

This part is known for having pits. We put new ones in every pump we rebuild. If you have any pits at all, it can tear the seals and take in water. So replace this part. This is for any of the H model pumps. The H pumps are 2" taller than standard. They are used on Diamond plows, Meyer MDII and Plus mounts.  

When this is out of the pump, the overall length is 13", the length not counting the stud at the bottom is 11", the pin hole is 5/8", the stud takes a 1/2" nut and the ram is 1-1/8",

This ram was used in these pumps: E-47H, E-46H, E-45H, U13H, E-60H, E-57H, E-58H, E-50H, V-66, E61H, E68, E78 and E88.

Make sure you also pick up a basic seal kit, the Genuine Meyer fluid you need and the Meyer yellow paint to do a proper rebuild. If you are doing this yourself, below we have links to the service manuals to walk you through the rebuild.

E-47, E-46 Complete Service Rebuild Manual

E-47, E-46 Parts Break Down

E-47H, E-46H Parts Break Down

E-58, E68, E-78, E88 Shop/ Repair Manual

E-58, E-68, E-78, E-88 Parts Break Down