42383 Blizzard Snowex Western 8600SW Speedwing Prodigy Wing Cutting Edge Kit 3 Bolt Edges

Here is a Set of the Factory 42383 Wing Edges for the Blizzard 8600SW Snowex 8600SW & Western Prodigy. 

*The early Blizzard 8600SW has 2 bolt edges and you would need part # B61650 instead.  

These are 1/2" thick edges.  

This comes with the bolts to attach kit, left side, right side and 2 spacer bars. 

Please refer to the photos to see the measurements for the bolt holes so you can check your pattern.

*Note: These can not be installed with a worn center cutting edge. If your center edge has a lot of wear, these will sit below that edge. Make sure your cutting edge measures close to 6" - if not, that will need to be replaced as well. The part # for the center cutting edge is 49799.