B61650 Blizzard 860SW 8600SW Speedwing 1/2" Wing Cutting Edge Kit 2 Bolt Hole Edges

Here is a Set of the Early Factory B61650 Wings for the Blizzard 860SW and the early 8600SW. These only fit the early ones. These are 2-bolt wing edges. The later ones are 3-bolt part # 42383.

These are 1/2" thick edges.  These have the built in curb guards.

This comes with the bolts to attach kit # B61646. Left side is B61610, right side is B61611 and we also sell them individually.

Please refer to the photos to see the measurements for the bolt holes so you can check your pattern.

*Note: These can not be installed with a worn center cutting edge. If your center edge has a lot of wear, these will sit below that edge. Make sure your cutting edge measures close to 6" - if not, that will need to be replaced as well. The part # for the center cutting edge is B61648 1.2" x 6'7" With hardware   B61570 Just edge.