57865 Western Steel Cutting Edges for 810 WideOut Wings Upgrade Kit Replaces 50626

These are Western Steel Cutting Edges 57865 designed specifically for use on the wings of a WideOut plow. This is also an upgrade kit for the older version that had the poly edges 50626 on the original Wideout. These are the standard cutting edges on the new 810 Wideout Series 2. 

We also sell an aftermarket replacement set for them, listed in related products. 

These cutting edges give the ability to choose between using a poly edge on your wings or steel edges (57865). The poly edges are 50626 on the old version and 81994 on the new version.

There is also a newer poly wing edge with curb guards built in, part # 80259 a semilar poly set is 80261.

They are 1/2" thick.

You can find the parts list and installation instructions for these cutting edges at this link.

With this kit you get DS Edge (11007 kit / 81148 edge), PS Edge (11008 kit,  81149 edge) and Bolt Kit 11009 / 11010.

*Note: These can not be installed with a worn center cutting edge. If your center edge has a lot of wear, these will sit below that edge. Make sure your cutting edge measures close to 6" - if not, that will need to be replaced as well. The part # for the center cutting edge is 64775.