A New 1.5x10" set of Genuine Diamond Power Angling Cylinders (part # 817000 020).
A New set 1.5x10" Genuine Diamond Power Angling Cylinders (part # 817000 020). These were pulled out of new pump kits that we took apart. You get just what you see. They have hoses, couplers, and oil in them already. This was used on all the Diamond blades with 1" pin holes. The cylinder assembly #s are 80061 and 80062. The hose part # is 816000095034, elbow is # 8752202004004. The couplers on the hoses are part #s 22291 and 22292.
These are often all pitted and at that point they should be replaced since those pits take in water and will cause freeze up in the pump. So get a new set on there and flush all the fluid out. We have the hoses listed here for the swap.
Here are some measurements to make sure this is what you need: the pin holes are 1", the port is 1/4" pipe thread and comes out the side of the cylinder, in the closed position the center of hole to center of hole is 17-1/4", closed end to end measures 18-3/4".
This is an OEM cylinder, but the aftermarket # on these cylinders is 1304100.
