Truck Side Meyer/Diamond Touchpad Control Harness Wiring Kit Power Cables Solenoid

Here is the Meyer Truck Side Wiring Harness Kit most commonly used on the Meyer Classic, MDII and Plus mounts. This is for the touchpad control so, if you are swapping trucks and all you have is the control, this kit will give you the Touchpad Harness 15764, Power Cable 15671, Ground Cable 15672, Battery Wire 05024 and Solenoid. The power and ground have the quick disconnect ends to plug into the harness on your pump. If you need the pump side, it is here. This kit does not include the light wiring. Meyer had many different light harnesses. We have them, but we need to match up the correct one for your lights.  If you are changing trucks, this gives you what you need. Pick out the correct light harness and you are set. You have control mounting bracket and all wiring. Look at the pictures to see what you get. Below are some wiring instructions.

This is made for the touchpad with the 6-pin white rectangle plug 22154.

If your touchpad has a round plug, you will need a different harness. Let us know and we will substitute.

For light wiring, you will need to identify what light you have.

The common rectangle lights say "Made by Truck Lite" on top they used 80830 Harness and the switch 08550.

If you have a teardrop-looking lights saying "Nite Saber" on top, you need module kit 07548 and the adapters that match your vehicle.