Winter Equipment Cutting Edge Xtendor Weld-On Curb Guard Carbide Matrix

Winter Equipment Weld-On Xtendor Edge.

This welds onto your blade (we have bolt-on ones, too) with a new cutting edge. It has a built-in curb guard and will extend the life of your cutting edge, as well as help the cutting edge to wear evenly. These come in a set of two and there are two sizes. 

These are 5-3/4" tall and 1-1/8" thick. The ground contact is 9" on each guard, so you will have 18" of the carbide matrix on the ground. 

*Note: These cannot be installed with a worn cutting edge. If your edge has a lot of wear, these will sit below that edge. Make sure your cutting edge measures close to 6". If not, that will need to be replaced as well. 

For more information, check this link.

The Installation Instructions can be found here.

Will fit the plows below with cutting edges installed:

Western - Models with 1/2" Holes

49212 Western Tri-V

58811 6' Blade

49070 7' Standard Blades with Top Punch 

49076 & 49088 7'6" Standard and Pro Blades with Top Punch

49080 & 49089 8' Pro Plow Top Punch

49086 8'6" Pro Plow Top Punch

Fisher -

Minute Mount L&M Series - 5532 7'6" Blades,  5533 8' Blades, 26460 8'6" Blades

27580, 6598 8' Blades

16384, 6597, 58814 -  7'6" Blades 

Meyer -

ST7' - 09132

ST7.5' - 09796

C7.5' - 09796

C8' - 09133

C8.5' - 09134

ST6.5' Blade - 09104

7' Blade - 09105

7'6" Blade -09257

Boss -

7'6" RTII V Plow - BAX0002 7'6"

RT3 V Plow - BAX0097

10' RT3 V Plow - BAX7627