Aftermarket 50626 Western WideOut Poly Wing Cutting Edges Fisher XLS 50645

Here is an aftermarket set of Poly Wing Edges. This is kit # 50626.

You get two of the urethane edges (part # 50645) and the bolts and nuts needed to install. This is the same for the Western WideOut plow and the Fisher XLS.

If you need the steel retainer bar that goes in front of the edge that is part # 50644 and is not included with these edges.

For the Western Wideout we also now have an upgrade Steel Edge kit, part # 57865.

There is also an updated version with built in curb guards kit part # is 80259. Or they sell a full poly edge set part # 81994, or wing edges 80261.

*Note: These can not be installed with a worn center cutting edge. If your center edge has a lot of wear, these will sit below that edge. Make sure your cutting edge measures close to 6" - if not, that will need to be replaced as well. The part # for the center cutting edge is 64775.