05752 Genuine Meyer PIPE 2x12 Power Angling Cylinder *Scratch and Dent*

These are New Cylinders but from being on the shelf the paint is chipped up being sold at a discount. 

This is a new Genuine Meyer 2x12" Power Angling Cylinder for a Meyer plow. These are the heavy duty ones used on the Meyer HM plows. They can be used on most C (commercial) blades, if you want larger cylinders. These are new cylinders we pulled out of new pump kits they may have scratches on them. This is the original part # 05752 They have Pipe thread There is an updated # 05752 that has an oring fitting. 

We also have 1.5x10 and 1.5x12 cylinders. These cylinders are often pitted and at that point they should be replaced, as those pits take in water and will cause freeze-up in the pump. Get a new set on there and flush all the fluid out. We have the hoses listed here for the swap. 

Meyer has a few cylinders, so make sure this is what you need. This style has been used since the late 70's.

The measuring system is often misunderstood. This is a 2x12" angling cylinder. The 2" is telling you the size of the rod, and then the 12" is giving you the movement. So it would be the difference between full open (31.5") and full closed (19.5") or 12" movement. These have a 5/8" hole in either end of them. There is a port on the side for a 1/4 pipe thread for the hose. We also have some available with the o-ring fittings. (If you measeure center to center of the bolt holes it is 18" fully closed.)

Meyer used the part # 07572. They also sold them with hoses and couplers using parts #'s 07023 and 07024.

Buyers/ SAM uses #1304015 for the aftermarket version.