This listing is for a set of New Genuine Meyer Cylinders with Hoses. These are pulled out of new pump kits, so there are nicks and scratches in the paint. But these have never been installed.
Genuine Meyer 1.5x12" cylinders. The left assembly is 07021 and the right assembly is 07022. You are getting two of the Meyer 05437, two of the 90 elbows 21857 and two hoses 22144. They are pre-filled with fluid from the factory.
These were used on most C (commercial) blades. We also have 1.5x10 and 2x12 cylinders.
These have the hose port in the side of the cylinder. These are often all pitted and at that point they should be replaced. Those pits take in water and will cause freeze up in the pump. So get a new set on there and flush all the fluid out. We have the hoses listed here for the swap.
Make sure you get a new bolt kit for these cylinders. They are listed in Related Products.
Meyer has a few cylinders, so make sure this is what you need.
The measuring system is often misunderstood. This is a 1.5x12" angling cylinder. The 1.5" is telling you the size of the rod and the 12" is giving you the movement. The movement is the difference between full open (31.5") and full closed (19.5") or 12" movement. If you measeure center to center of the bolt holes it is 18" fully closed.
These have a 5/8" hole in either end.
There is a port in the side (not on top) for a 1/4 pipe thread for the hose.
